This is really pretty self explanatory, see the gallery below. Also, my original plan failed miserably as it was a terrible idea (with the bearing and plywood spindle. In the end I made it much simpler.
The plan was to make a base that fits in the boot with a small table that pivots out of the boot, providing some space to prepare milkshakes.
I thought perhaps I could crush the plywood spindle with a bolt, squeezing the plywood out, holding it in the bearing. Terrible idea.
After giving up on that idea, I just stuck some bolts in the side of the original support, ripped some strips of plywood and stuck em on the table.
Leave a Reply